Hotpoint-ariston Top loading ECOT7F 129 (EU) User Manual download pdf (Page 2)

Installation

! Keep this instruction manual in a safe place for future

reference. Should the appliance be sold, transferred or

moved, make sure the instruction manual accompanies

the washing machine to inform the new owner as to its

operation and features.

! Read these instructions carefully: they contain vital infor-

mation on installation, use and safety.

Unpacking and levelling

Unpacking

1. Unpack the washing

machine.

2. Check whether the

washing machine has

been damaged during

transport. If this is the

case, do not install it and

contact your retailer.

3. Remove the four

protective screws and

the rubber washer with

the respective spacer,

situated on the rear of the

appliance (see figure).

4. Seal the gaps using the

plastic plugs provided.

5. Keep all the parts: you will need them again if the wa-

shing machine needs to be moved to another location.

Warning: should the screws be re-used, make sure you fasten

the shorter ones at the top.

! Packaging materials are not children’s toys.

Levelling

Your machine may make a considerable amount of noise if

the two front feet have not been adjusted correctly.

1. Install the washing machine on a flat sturdy floor, without

resting it up against walls, furniture cabinets or other.

2. If the floor is not perfectly

level, compensate for any

unevenness by tightening or

loosening the adjustable front

feet (see figure); the angle of

inclination, measured accor-

ding to the worktop, must not

exceed 2°.

Levelling your appliance

correctly will provide it with

stability and avoid any vi-

brations, noise and shifting

during operation. If it is placed on a fitted or loose carpet,

adjust the feet in such a way as to allow enough room for

ventilation beneath the washing machine.

Putting your appliance in place and moving it.

If your washing machine

is equipped with a special

set of retractable wheels

you can easy move it.

To lower the wheels and

thus move the appliance

effortlessly, just pull the

lever, situated on the left-

hand side beneath the

base. Once the appliance

is in the required position,

put the lever back in

place. The washing

machine is now firmly in place (see figure).

Electric and water connections

Connecting the water inlet hose

1. Connect the supply pipe

by screwing it to a cold

water tab using a 3/4 gas

threaded connection (see

figure).

Before performing the con-

nection, allow the water to

run freely until it is perfectly

clear.

2. Connect the other end

of the water inlet hose

to the washing machine,

screwing it onto the ap-

pliance’s cold water inlet,

situated on the top right-

hand side on the rear of

the appliance (see figure).

3. Make sure there are no kinks or bends in the hose.

! The water pressure at the tap must be within the values

indicated in the Technical details table

(on the next page).

! If the water inlet hose is not long enough, contact a

specialist store or an authorised serviceman.

1 2 3 4 5 6 7 ... 71 72

Comments to this Manuals

No comments

Hotpoint-ariston Top loading ECOT7F 129 (EU) User Manual Page 2

Comments to this Manuals

Related products and manuals for Washers Hotpoint-ariston Top loading ECOT7F 129 (EU)