Hotpoint-ariston WMSF 602 User Manual download pdf (Page 3)

3

GB

Connecting the drain hose

Connect the drain

hose, without bending

it, to a drain duct or

a wall drain situated

between 65 and 100

cm from the floor;

alternatively, placed

it over the edge

of a basin, sink or

tub, fastening the

duct supplied to

the tap (see figure).

The free end of the

hose should not be

underwater.

! We advise against the use of hose

extensions; if it is absolutely necessary, the

extension must have the same diameter as the

original hose and must not exceed 150 cm in

length.

Electrical connections

Before plugging the appliance into the

electricity socket, make sure that:

• the socket is earthed and complies with all

applicable laws;

• the socket is able to withstand the

maximum power load of the appliance as

indicated in the Technical data table (see

opposite);

• the power supply voltage falls within the

values indicated in the Technical data table

(see opposite);

• the socket is compatible with the plug of

the washing machine. If this is not the case,

replace the socket or the plug.

! The washing machine must not be installed

outdoors, even in covered areas. It is

extremely dangerous to leave the appliance

exposed to rain, storms and other weather

conditions.

65 - 100 cm

! When the washing machine has been

installed, the electricity socket must remain

within easy reach.

! Do not use extension cords or multiple

sockets.

! The cable should not be bent or

compressed.

! The power supply cable must only be

replaced by authorised technicians.

Warning! The company shall not be held

responsible in the event that these standards

are not observed.

The first wash cycle

Once the appliance has been installed, and

before you use it for the first time, run a wash

cycle with detergent and no laundry, using

wash cycle number “Auto Clean”.

Technical data

Model

WMSF 602

Dimensions

width 59.5 cm

height 85 cm

depth 43,5 cm

Capacity

from 1 to 6 kg

Electrical

connections

please refer to the technical

data plate fixed to the ma-

chine

Water con-

nections

maximum pressure

1 MPa (10 bar)

minimum pressure

0.05 MPa (0.5 bar)

drum capacity 48 litres

Spin speed

up to 1000 rotations per

minute

Test wash

cycles in

accordan-

ce with

directives

1061/2010

1015/2010

programme

; Cotton

Standard 60°C;

programme

; Cotton

Standard 40°C.

This appliance conforms to

the following EC Directives:

- 2004/108/EC (Electroma-

gnetic Compatibility)

- 2006/95/EC (Low Voltage)

- 2002/96/EC

1 2 3 4 5 6 7 8 ... 83 84

Comments to this Manuals

No comments